Install Reflective Road Studs (2)

The third step of reflective road stud installation: Mixing Epoxy (or cement) special for reflective road stud. The ratio of a glue and B glue is 1:1 (e.g. 1kg of a glue and 1kg of B glue). The glue must be stirred evenly and have the same color. Pour the glue or cement into the hole of the reflective road stud.

The fourth step of reflective road stud installation: put the reflective road stud product into the hole, rotate and adjust the LED light of the reflective road stud to the required direction, use glue or cement moderately, not only stick the reflective road stud, but also do not overflow too much (the overflow part should be wiped off with cloth in time).

Apply glue to the bottom of the reflective road stud and the road surface where the reflective road stud is installed, and then gently hammer the top of the reflective road stud with a rubber hammer to make it flat and completely fix the reflective road stud.

reflective road stud installation step 5: wiring. Before wiring the reflective road stud, please make sure that the power supply voltage is the same as the lamp voltage. reflective road stud installation step 6: connect the power line correctly according to the label on the cable, and distinguish the positive and negative poles. The seventh step of reflective road stud installation: after connecting the wire, check the wiring, and then turn on the power supply. After the power is turned on, the reflective road stud starts to work normally.